The container boxes that are just in the bath must be carefully positioned. Block may close the door framing to hold the switch and cover plate to switch from the path of the door casings are required, and electrical outlets will need to take into account the height of vanity backsplash in determining the position of the vanity. Double sink should be a way out between the two sinks or electrical outlets, each set made of 12 inches on both sides of the basin. Because someMedicine cabinets have a built-in lighting and are wired, you may not need a fixed size for the decoder, and if this is the case, you can simply run a long cable and hard-wire into the cabinet when is mounted later. Vanity lights and ceiling fans and lighting, which is almost anything but wired medicine cabinet with integrated lighting Boxes mounting bracket is required (for the lighting surface), housing, or downlightCombination fan / light and fan / light / heater.
A box of pancake, the most common type of attachment box is round and about 1/2in. 3-1/2in thick. or so in diameter, although a bit 'larger diameters and depths are available. The lamp is mounted directly on the box of pancakes or a mounting plate that is screwed to the box, and boxes can be mounted on wall or ceiling. (By the way, do not use plastic containers boxes attached to the ceilingValves because they are not strong enough.) In most cases, even the pancake boxes are collected and can be mounted directly screwed to the wall or ceiling and below the picture, because usually completely covered by the device. Recessed lighting generally have their own self-contained junction box wire.
Bathroom Light Fixtures
They are usually mounted on the design with metal coat hanger, with the bottom of the container is flush with the bottom of the frame. SomeRecessed lighting housings are rated for contact with insulation (known as IC devices) and can be used in attic spaces. Thermal-housing (so-called T-taps) have thermal protection, to interrupt the electrical connection when the device becomes too hot, and always have at least 3 cm from insulation cover. How recessed light fitting, fan combination light / fan event / lighting / heating on the usually design with metal hangers. These unitsare not usually mounted shower in the immediate vicinity if they are classified for use in wet environments. If the fan has a remote device can be installed later if the site is accessible, even though the provisions for the operations of the duct, and electrical connections must be made.
Electric bathroom - Socket Box, light and fans
ไม่มีความคิดเห็น:
แสดงความคิดเห็น