Fluorescent lights are one of the best ways to get the most out of your lighting. Kitchens, bathrooms, basements and garages are just some of the many rooms, fluorescent lighting is good help. Fluorescent lights provide a soft shine, burn less energy and produces a minimal amount of heat. Gas to the fluorescent light excited by an electric charge, then in a plasma state, that lights the fire creates.A fluorescent ballast inside the office is responsible for the initial installation. This can often go and be replaced. Use this guide to the right ballast for fluorescent light to find your.
Check the bulbs
Bathroom Light Fixtures
If you change a fluorescent light bath or kitchen before you start to change in ballast to replace bulbs. More often than not, is a fluorescent light works not only because ofBulbs. If you change the light bulbs and turn on the light without success, the ballast must be replaced.
Find the ballast
Before working on the electric light, turn the switch in the room you are working. Most reactors are inside the light itself is often the ballast of a black rectangular box. He has only two wires connected to the device. There are two ways connected to the ballast wiring.One of the wires are connected directly into the gravel and should be cut. Or two, (the preferred method), the wires are attached to the ballast with two small screws.
Removing the
More often than not, the fluorescent lamp mounted on the same medium. This means that you can have all the light from the ceiling or wall, remove the screws that hold the ballast in place for access. Some reactors are truncated Place a small metal rod. Carefully remove the ballast and the screw threads. If the wires must be cut, make, how much yarn to light as much as possible.
Replacing the ballast
The search for a new reactor is simple. Just take the old store to the grid and buy a new replacement. Always meet or fluorescent lights do not work. Note to ensure the number of tubes, the length and type of an exact match for your fluorescent> Light.
Putting it all together
The replacement of the old ballast is as simple as reversing the previous steps. If you are instead of cutting wires, rotate the two ends together in a clockwise direction, especially with the nut flush properly. Never use adhesive tape or other ballast wire. Plastic cable connector, perfect, the only way to avoid dangerous electrical shocks or disturbances in your fluorescent light.
Replace a fluorescent ballast
ไม่มีความคิดเห็น:
แสดงความคิดเห็น