Because, as I never cashed the lighting will be installed before I do not have the diligence research on the Internet before I bought something. What I found is that there are different sections for new construction and renovation. There are also other devices, even if the device is mounted on the ceiling can be in contact with insulation or not. Once I knew what I had to choose, has made it much easier when Ihardware store. I always ended up that for the transformation with a designation of IC, which is in contact isolation.
The first thing I had to install the cable to the ceiling, where I like the light would go. Then I had the pin finder to see if there are studs in the road. Yes, you guessed it. I understood where the prisoners were before me, where I wanted the lights, because now that have marked shift. No problem, though, because there is noHoles still. Now that I moved to the position I am ready to cut the holes. When I use the lights came with your model, so I cut the right size holes. I have a drywall saw to cut the holes. It worked very well and the instrument is only about $ 3 verses of "special drywall hole saw" that will seek $ 25, or for sale.
Bathroom Light Fixtures
Now that the holes are, I went to the attic to see where I could run the power lines and found that I can not reach athe device, so I proposed that a wire, even before installing it. Once I went to the bathroom I wired the first machine and pushed the wire through the hole and then slipping the device into the hole. When the unit is flush with the drywall, there were three spring clips, which have to press to hold it in place. What they do is grip the flange of the mount against the drywall so that it can not be persuaded. After the first point ofI caught the wire and secure from the first through the second hole and wired so that they are good in that way.
If the second point was, I came back to finish the wiring in the attic. Since we already had a light mounted on the wall, I managed to find the junction box and splice in this circuit, so come the new lights make the switch exists that the switch was turned off before I started so I do not c 'had no power to the junction box. The lastThings I had to do was to install the bulb, try the switch to ensure that everything works and then install the face plates. The face plates I used were those that have a seal in it could not affect the moisture from the shower the lights.
Simple steps to install recessed lighting in the bathroom
ไม่มีความคิดเห็น:
แสดงความคิดเห็น